![]() Tech
support for 2021 1200cc carb engine (other
years here)
|
||
|
2021-22 Parts Microfiche '21 ECU install 2021 Owners Guide (No beginner/intermediate/beast mode) If you buy a ski from us we will provide tech suport. If you buy parts from us we provide tech support for those items. All other support will need to be from your own dealer/supplier or Krash direct at support@kavincimotors.com Or you can purchase time from us here.. |
2021 Troubleshoot E bar loom 2021 Troubleshoot E bar loom 2 2021 Troubleshoot Regulator 2021 Troubleshoot Stator 2021 Troubleshoot Hall Effect 2021 Troubleshoot Start Stop Switch 2021 Fuse box layout V1 2021 Fuse box layout V2 2021 New ECU pin change if your stop and lanyard switch dont work 2021 Ecu plug to New Microsquirt ECU |
|
|
|
Our '21 1200cc skis at 500ft elevation, about 70 degree air and water
temps, run best with the low screws at 3/4 turn out and Highs at 1/2
turn out with unmolested stock carbs.
| |
|
2021
Hall effect sensor troubleshoot 2021 Flywheel mod, Kavinci ECUs must be sent to Krash for programing and one tooth needs removed from the flywheel. We can reprogram Microsquirt EUC's. Video |
Do not use a Kawasaki or other
aftermarket lanyards unless the clip is as thick as the stock one or
it will not spark.
Approved Lanyards here |
|
Click here to see all the 2021 1200cc improvements/changes |
You can hook up your '21 carb Microsquirt
ECU to a computer to do troubleshooting etc. The cables are available here If You have a Kavinci ECU then check for an LED light in the middle and if it does not have this the updates have not been performed and you may want to consider upgrading to a Micro Squirt ECU and performing the flywheel mod. |
|
| VIDEOS '21 specific tech video '21 ECU install Fuel system priming with carbs Fuel Tank Pressure Relief Valve testing Fuel line routing with carbs |
||
Krash Skis All Krash Parts Sign up for the NEW Krash Industries Owners Portal today! https://www.krashindustriesowners.com |
Looking for something else? contact us | |








