Snowmobile Handlebar Riser Blocks
We also sell risers from -
RSI Handlebar Risers. RSI makes one of the most diversified pivoting
handle bar riser block systems available.
RSI and Fly products are very
similar and interchangeable.
Top inserts fit 7/8" standard bars or remove to fit
1 1/8" fatty bars
RSI Pivoting Handlebar Risers $69.95 - $79.95
adjustability allows you to position handlebars where you want them.
Available in 1.5", 2", 3", 4", 5", 6", 7", 8", 9" and 10" heights.
Each pair of risers Comes with custom inserts that allows risers
to fit stock 7/8" handlebars and oversize 1 1/8" handlebars.
6061 T-6 Aircraft aluminum
For use with pivot style steering posts or steering posts with adapter
Anodized finish in black.
Note: Double check length of cables
and brake lines for proper fit. Extended length cables or brake lines
may be required for proper operation.
post pivot adaptor $22
Converts flat style steering post to double pivot style.
Cro-Molly and Hi-Temp steel construction. Simple bolt on design. Works
with RSI risers and other 2 piece aftermarket risers. Adds 3/4" of
Since these pivot adapters put the
risers on the outside of the steering post plate the widths of the
clamping surface varies. Double check the clamp surface area
width on your stock bars to make sure it is wide enough for the risers
to clamp down on a flat surface and not into the curve of the
CLAMP SURFACE WIDTH MINIMUMS FOR RSI RISERS
Arctic Cat and Polaris 116mm
RSI Snowmobile Handlebar Pads $24.95
Designed specifically for snowmobiles.
Heavy duty outer nylon with TPR rubber logos will not
separate or crack in the coldest weather.
Large size fits most aftermarket and factory handlebars and risers.
||RSI Angled Handlebar Risers
30 DEGREE FITS: All Polaris (Except 2009'), Ski-Doo Rev and ZX
Chassis, All Arctic Cat (Except M-Series Chassis), Yamaha Mtn Max, SX,
15 DEGREE FITS: ALL Arctic Cat M-Series and Crossfire Chassis and
2009' IQ Polaris with flat style steering posts.
||RSI extended brake lines
6" longer than stock length brake lines.
Teflon line and stainless steel braided hose with a clear UV protected
Swivel fittings on non banjo lines
||RSI extended length throttle
8" longer than stock. This is a complete throttle cable replacement.
You may only need the throttle cable extension kit below.
Call for sled model availability.
PowerMadd Throttle Cable extension kit
note: will not fit '07-'08 Arctic Cat F series
to see a step by step installation of two different styles of bar riser
More risers can be seen here: POWERMADD SPORTECH FLY